CREATOR WORKFLOW
How to set microphone gain before recording a voiceover
Use a loud test line, the input meter, and a playback check to get a clean voiceover before recording the full script.
By Colquhoun Studio editorial
Test with the loudest line, not the first line
Set up the microphone where you will actually use it. Pick the loudest sentence in the script and read it the way you plan to deliver it. Then read one quieter line. A gentle mic check can miss the louder emphasis that will happen in the real take. Keep your distance from the mic consistent while you compare the tests.
Watch the recording meter
Open your recorder's input meter. If the meter shows decibels relative to digital full scale, 0 dBFS is the top of that scale, not a target. Audacity's recording guide suggests making the loudest test peaks around −6 dB on its recording meter. Use that as a starting point, not a target for every syllable. Leave room for a louder delivery on the real take. Source: https://manual.audacityteam.org/man/recording.html
Turn down the input, not your headphones
If the meter shows overload, reduce the recording input or the gain on your audio interface and try the line again. The headphone volume knob only changes what you hear. If the audio still sounds rough with a safe reading, check whether an earlier device in the chain is overloading. For example, lower the physical interface gain and record a fresh test instead of just turning down the track in your editor.
Listen to the recorded test
Record ten to fifteen seconds with a normal pause between the two lines. Stop and play back the actual recording through headphones. Listen for a crunchy edge on louder words, bursts of air on P or B sounds, or distracting room noise on the quieter line. If air hits the mic, move it a little to the side or use a pop filter and run the test again. If the loud line clipped, lower the input and retake it; editing the playback level will not restore the lost peaks.
Save the setup for pickups
Note the input device, gain setting and roughly how far you stood from the mic. Keep the short test clip until the video is finished so you can compare it with a pickup. When the room, mic, or way you read changes, run the same loud-and-quiet test before recording the next take.