CREATOR WORKFLOW

How to test for light flicker before filming a demo

Spot moving bands and pulsing light before recording a full demonstration. Compare short clips and keep the setup that works.

By Colquhoun Studio editorial

Record a clip you can compare

Put a plain sheet of paper next to the object you plan to film. Use the same camera mode, frame rate, lights, and dimmer settings as the real demo. Record about ten seconds: hold the scene still, then move a hand through the frame at your normal pace. Play back the recorded clip rather than relying on the live view. A plain surface makes moving stripes and changes in brightness easier to see.

Isolate the source before changing camera settings

Record another clip with one light switched off, then test any monitor or illuminated sign in the shot separately. Keep the framing and camera settings the same so you can compare clips. If stripes disappear when a desk lamp is off, replace it, move the setup, or try an undimmed setting and retest. If the problem appears only on a display, consider taking a screen recording and cutting it in rather than filming the display.

Treat shutter speeds as starting points

If your camera has a video flicker reduction setting, try Auto first, then compare the 50 Hz and 60 Hz settings if available. For manual exposure, Nikon's Z 50 movie guide gives 1/50 or 1/100 second as examples in 50 Hz power regions and 1/60 second as one option in 60 Hz regions. Those are starting points, not guarantees. Some LEDs need finer shutter adjustment; if your phone doesn't offer shutter control, change the lighting instead. See Nikon's movie manual: https://onlinemanual.nikonimglib.com/z50/en/09_menu_guide_04_15.html

Check the fix in motion

A faster shutter may make hand movements look sharper and less smooth, and the shot may need more light. After changing one setting, repeat the same movement. Check that labels on the product are still readable, the striping is gone, and the hands look natural for the demo. Open the comparison clips on a larger screen before committing to a full take.

Write down the working setup

Save one clean test clip and note the camera mode, frame rate, shutter setting if available, lights, and dimmer positions. For a future pickup shot, copy that setup and run the ten-second test again. If bands are already baked into an important clip, try reshooting the affected close-up before spending time on a filter that may leave visible artifacts.